| Next: MXM(1) Up: WFDB Applications Guide Previous: MFILT(1) | On This Page |
mrgann reads a pair of annotation files (specified by ann1, ann2) for the specified record and writes a third annotation file (specified by ann3) for the same record. Typical applications of mrgann include combining annotation files that apply to different signals within a multi-signal record, and replacing a segment of an annotation file with annotations from another file (see the examples below). mrgann cannot concatenate annotation files from different records (e.g., segments of a multi-segment record); use wfdbcollate(1) for this purpose. If you wish to merge annotation files in order to be able to study or resolve the differences between them, bxb(1) (which can also merge annotation files using its -o or -O options) is almost certainly a better choice for such an application.
By default, the output annotation file contains copies of all annotations in each of the input files (if there are annotations with the same time and chan fields in each input file, however, only the annotation from ann1 is copied). This behavior can be modified by command-line options, which include:
Note that options are interpreted in left-to-right order. For this reason, if you specify more than one -mx option, as in the second example below, be sure to specify them in time order. It is also possible to use different chan mapping rules during different segments of the record; to do this, specify the appropriate -c or -C option(s) before the -mx option that specifies the time when the new mapping rules are to be applied.
To merge three sets of annotations
(named a0, a2, and a3, one for each of signals 0, 2, and 3 of record 999),
use the following commands:
mrgann -r 999 -a a0 a2 -o tmp -c 0 -C 2
mrgann -r 999 -a tmp a3 -o all -c -1 -C 3
Note that two passes are needed to merge three annotation files, since
mrgann reads only two annotation files at a time. The first pass yields
an intermediate result (annotator tmp); annotator all is the desired output.
The -c -1 option in the second command above disables chan mapping for annotations
in tmp, which have already been mapped as a result of the first command;
this option could have been omitted, since chan mapping is disabled by
default.
To replace any annotations in a set (named old) during the interval
between 5 minutes and 6 minutes from the beginning of record xyz, with
annotations from another set (named new), use the command:
mrgann -r xyz -a old new -o out -m1 0 -m2 5:0 -m1 6:0
In this command, the desired output is written to annotator out for record
xyz. The -m1 0 option overrides the default behavior and forces any new
annotations that occur before the 5-minute mark to be discarded, while existing
old annotations are copied to out. Beginning at the 5-minute mark, the -m2
5:0 option changes the rules, and the old annotations are discarded as
the new ones are copied. The rules are changed a third and final time at
the 6-minute mark by the -m1 6:0 option, which instructs mrgann to copy the
remaining old annotations to out, while once again discarding any new annotations
that occur during this interval.
It may be necessary to set and export the shell variable WFDB (see setwfdb(1) ).
Please e-mail your comments and suggestions to webmaster@physionet.org, or post them to:
PhysioNetUpdated 8 March 2019